精品久久久久久无码人妻,亚洲欧美日韩综合一区在线,久久大香香蕉国产拍国,人妻无码久久精品,亚洲区激情区无码区日韩区,最新无码专区视频在线,最近中文MV字幕免费高清在线7,中文字字幕乱码无线精品精品,色欲久久久天天天综合网,久久精品毛片少妇东京热

There are usually two ways to choose a coupling:

Select a suitable coupling according to the maximum torque, i.e. the peak torque required by the load should not exceed the rated torque of the coupling:

TKN ≧ 1.5 TAS Nm

The coupling is selected according to the acceleration torque. At this time, the rotational inertia of the drive system needs to be considered. If the inertia ratio is large, the influence of the load factor in the calculation of the coupling specification will be reduced:

Calculation example:

Servo motor drive, maximum torque TAS=50Nm

Load factor SA=3

So ，It can be seen that when the load inertia is relatively large, the inertia of the coupling itself has little influence on the calculation results.

In addition to the torque, it is necessary to consider whether the speed meets the requirements. Most of the R+W couplings have been preliminarily balanced before leaving the factory. The default speed of some smaller models can reach 10000rpm. If the equipment needs The rotation speed is relatively high, and additional dynamic balancing treatment is required.